Differences

This shows you the differences between two versions of the page.

--- latinet:unicaes:workshops:start [2023/08/25 01:58] – harley.lara
+++ latinet:unicaes:workshops:start [2023/08/29 21:30] (current) – harley.lara
@@ Line 1: / Line 1: @@
-====== Introduction to IoT ======
+====== Introduction to IoT Serie of Workshops ======
-Requirements:
+===== Requirements =====
   * Basic programming knowledge, preferably C or C++.
-  * Basic knowledge in electricity
+  * Basic knowledge in electricity,
+  * Foundations in digital and analog electronics
-Materials:
+===== Materials =====
   * Personal computer
   * Operating system: Any
   * Internet connection
-  * Dev board: Wemos D1 Mini
+  * Dev board: WeMos D1 Mini
   * Mico-USB to USB-A cable
   * Breadboard
   * Jumper wires
   * Sensors:
-    * sensor 1
+    * DS18B20 (temperature sensor)
-    * sensor 2
+    * Capacitive soil moisture sensor
-    * sensor x
+    * VL53L0X (ToF)
   * Actuator:
-    * actuator 1
+    * LED
-    * actuator x
-Session Outline:
+===== Session Outline =====
-Day 1:
+[[latinet:unicaes:workshops:intro-to-iot-23| Day 1: Introduction to IoT]]
+  * Introduction to IoT
   * Setup development environment
     * Install Arduino IDE
@@ Line 33: / Line 34: @@
   * Coding Warm-up
     * LED Blink
-    * Sensor reading?
-Day 2:
+[[latinet:unicaes:workshops:sensors-23| Day 2: Sensors and Communication]]:
-  * Communication protocols
+  * PWM
-    * HTTP
+  * Just analog (Capacity sensor)
-    * MQTT
+  * 1-Wire (temperature sensor)
-    * Websocket
+  * I2C (ToF sensor)
-Day 3:
-  * Firmwares
+[[latinet:unicaes:workshops:communication-23| Day 3: IoT Communication]]:
-    * Tasmota
+  * MQTT
+[[latinet:unicaes:workshops:nig | Day 4: NIG stack]]:
+  * Setup docker
   * Node-RED
-  * Dashboarding
+  * Influx
-    * Grafana
+  * Grafana