HSRW EOLab Wiki

User Tools

Site Tools

Trace: • utility-drones • cargo • iot-workshop • haw-frq • kubernetes • sidebar
user:jan001:intro_iot_tasmota_nig

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
user:jan001:intro_iot_tasmota_nig [2021/10/11 13:27] – jan001user:jan001:intro_iot_tasmota_nig [2023/03/28 15:21] (current) – [Doing stuff] rolf.becker
Line 64: Line 64:
 Allons-y! Allons-y!
  
 +==== DS18B20 Pinout ====
 +
 +  * Cable VErsion: red -> 3.3V , blue -> GND , yellow -> data (1wire protocol)
 +  * Breakout board version: "+" -> 3.3V , "-" -> GND, out -> data 
 ==== Breadboard prepartion ==== ==== Breadboard prepartion ====
 So get all your stuff together and build up the breadboard. Here is the schematic. If your Programmer has male headers, you can plug it directly into the breadboard. {{ :user:jan001:intro-iot_bb.png?600 |}} So get all your stuff together and build up the breadboard. Here is the schematic. If your Programmer has male headers, you can plug it directly into the breadboard. {{ :user:jan001:intro-iot_bb.png?600 |}}
 +
 +<WRAP center round alert 60%>
 +\\
 +The data line of the 1Wire bus (blue) \\ is not connected correctly in the diagram above! 
 +</WRAP>
  
 ==== Installing the Tasmotizer ==== ==== Installing the Tasmotizer ====
Line 167: Line 176:
   - [[https://github.com/tasmota/tasmotizer|Tasmotizer - Jacek Ziółkowski - 2019]]   - [[https://github.com/tasmota/tasmotizer|Tasmotizer - Jacek Ziółkowski - 2019]]
   - [[https://tasmota.github.io/docs/|Tasmota Community]]   - [[https://tasmota.github.io/docs/|Tasmota Community]]
 +  - [[https://www.sensatio.io/sensors/dallas-ds18b20|Dallas DS18B20]]
user/jan001/intro_iot_tasmota_nig.1633951662.txt.gz · Last modified: 2021/10/11 13:27 by jan001