HSRW EOLab Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Introduction to IoT ======
Welcome to Day 1 of our IoT Workshop! Today, we introduced the basics of IoT through presentations and hands-on activities, covering topics from setting up your development environment to hardware essentials and soldering.

===== 1. IoT Intro Presentation =====
{{pdfjs 500px>:latinet:unicaes:workshops:intro_to_iot.pdf?75}}

===== 2. Setup Development Environment =====

  * [[https://www.arduino.cc/en/software#future-version-of-the-arduino-ide|Install Arduino IDE]], for more information see the [[https://docs.arduino.cc/software/ide-v2|Official documentation]]
    * [[https://randomnerdtutorials.com/installing-esp8266-nodemcu-arduino-ide-2-0/ | Installing ESP8266 NodeMCU Board in Arduino IDE 2.0]]
  * [[https://learn.sparkfun.com/tutorials/how-to-install-ch340-drivers | How to install CH340 driver]] - [[https://learn.sparkfun.com/tutorials/how-to-install-ch340-drivers#drivers-if-you-need-them|Driver Download Section]]


===== 3. Hardware Review =====

  * Dev Board: Wemos D1 Mini 
  * Microcontroller: ESP8266 12-E Chip [[https://randomnerdtutorials.com/getting-started-with-esp8266-wifi-transceiver-review/| ESP8266 hardware review]]

===== 4. Soldering =====

Here it gets practical! You need to solder the microcontroller and some of the sensors, which you will need in the next session.
<imgcaption image1|In Action at UNICAES>{{ :latinet:unicaes:workshops:20230828_153840.jpg?400 | In Action}}</imgcaption>

===== 5. Coding Warm-up =====

Now let's check if your Microcontroller works. Also, you will learn how to upload your first sketch. Basic Blink example:

<file cpp Blink.ino>
void setup() {
  // initialize digital pin LED_BUILTIN as an output.
  pinMode(LED_BUILTIN, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
  digitalWrite(LED_BUILTIN, HIGH);  // turn the LED on (HIGH is the voltage level)
  delay(1000);                      // wait for a second
  digitalWrite(LED_BUILTIN, LOW);   // turn the LED off by making the voltage LOW
  delay(1000);                      // wait for a second
}
</file>


{{url>https://gfycat.com/ifr/BlissfulCriminalAnemoneshrimp 400,300 noborder fullscreen}}

===== Recording =====


===== Additional information =====

Additional information: [[user:jan001:intro_iot_tasmota_nig|Introduction to IoT - Sensors and Data processing]]