HSRW EOLab Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Introduction to IoT Serie of Workshops ======

===== Requirements =====

  * Basic programming knowledge, preferably C or C++.
  * Basic knowledge in electricity,
  * Foundations in digital and analog electronics

===== Materials =====

  * Personal computer
  * Operating system: Any
  * Internet connection
  * Dev board: WeMos D1 Mini
  * Mico-USB to USB-A cable
  * Breadboard
  * Jumper wires
  * Sensors:
    * DS18B20 (temperature sensor)
    * Capacitive soil moisture sensor
    * VL53L0X (ToF)
  * Actuator:
    * LED

===== Session Outline =====

[[latinet:unicaes:workshops:intro-to-iot-23| Day 1: Introduction to IoT]]
  * Introduction to IoT
  * Setup development environment
    * Install Arduino IDE
    * Install libraries
    * Drivers
  * Hardware review
  * Coding Warm-up
    * LED Blink

[[latinet:unicaes:workshops:sensors-23| Day 2: Sensors and Communication]]:
  * PWM
  * Just analog (Capacity sensor)
  * 1-Wire (temperature sensor)
  * I2C (ToF sensor)

[[latinet:unicaes:workshops:communication-23| Day 3: IoT Communication]]:
  * MQTT

[[latinet:unicaes:workshops:nig | Day 4: NIG stack]]:
  * Setup docker
  * Node-RED
  * Influx
  * Grafana