projects:wifi-cam:dev:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projects:wifi-cam:dev:start [2023/08/16 22:45] – [AI Thinker ESP32 Cam] rolf.becker | projects:wifi-cam:dev:start [2023/08/19 12:38] (current) – [ESP32 CAM Development] rolf.becker | ||
---|---|---|---|
Line 8: | Line 8: | ||
* TI datasheet {{https:// | * TI datasheet {{https:// | ||
* TI datasheet {{https:// | * TI datasheet {{https:// | ||
+ | |||
+ | ===== Mark's Bench (2020) ===== | ||
+ | |||
+ | * https:// | ||
+ | |||
+ | He uses a FET as a low side current switch to switch the GND of the ESP32-Cam. The FET is triggered by a PIR sensor which keeps its output high for 2 seconds in case of motion. | ||
===== AI Thinker ESP32 Cam ===== | ===== AI Thinker ESP32 Cam ===== | ||
Line 57: | Line 63: | ||
* [[https:// | * [[https:// | ||
- | ===== XIAO ESP32S3 | + | ===== XIAO ESP32S3 |
* {{https:// | * {{https:// | ||
* [[https:// | * [[https:// | ||
* LDOs for cam: https:// | * LDOs for cam: https:// |
projects/wifi-cam/dev/start.1692218738.txt.gz · Last modified: 2023/08/16 22:45 by rolf.becker