user:jan001:intro_iot_tasmota_nig
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
user:jan001:intro_iot_tasmota_nig [2021/10/11 13:15] – jan001 | user:jan001:intro_iot_tasmota_nig [2023/03/28 15:21] (current) – [Doing stuff] rolf.becker | ||
---|---|---|---|
Line 64: | Line 64: | ||
Allons-y! | Allons-y! | ||
+ | ==== DS18B20 Pinout ==== | ||
+ | |||
+ | * Cable VErsion: red -> 3.3V , blue -> GND , yellow -> data (1wire protocol) | ||
+ | * Breakout board version: " | ||
==== Breadboard prepartion ==== | ==== Breadboard prepartion ==== | ||
So get all your stuff together and build up the breadboard. Here is the schematic. If your Programmer has male headers, you can plug it directly into the breadboard. {{ : | So get all your stuff together and build up the breadboard. Here is the schematic. If your Programmer has male headers, you can plug it directly into the breadboard. {{ : | ||
+ | |||
+ | <WRAP center round alert 60%> | ||
+ | \\ | ||
+ | The data line of the 1Wire bus (blue) \\ is not connected correctly in the diagram above! | ||
+ | </ | ||
==== Installing the Tasmotizer ==== | ==== Installing the Tasmotizer ==== | ||
Line 156: | Line 165: | ||
=== Grafana === | === Grafana === | ||
- | We are nearly finished! Let's open up Grafana. Start with creating a new dashboard by hovering over " | + | We are nearly finished! Let's open up Grafana. Start with creating a new dashboard by hovering over " |
+ | {{ : | ||
+ | I hope you learned something today! | ||
===== References ===== | ===== References ===== | ||
Line 165: | Line 176: | ||
- [[https:// | - [[https:// | ||
- [[https:// | - [[https:// | ||
+ | - [[https:// |
user/jan001/intro_iot_tasmota_nig.1633950919.txt.gz · Last modified: 2021/10/11 13:15 by jan001