user:jan001:intro_iot_tasmota_nig
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
user:jan001:intro_iot_tasmota_nig [2022/06/28 11:14] – [Breadboard prepartion] rolf001 | user:jan001:intro_iot_tasmota_nig [2023/03/28 15:21] (current) – [Doing stuff] rolf.becker | ||
---|---|---|---|
Line 64: | Line 64: | ||
Allons-y! | Allons-y! | ||
+ | ==== DS18B20 Pinout ==== | ||
+ | |||
+ | * Cable VErsion: red -> 3.3V , blue -> GND , yellow -> data (1wire protocol) | ||
+ | * Breakout board version: " | ||
==== Breadboard prepartion ==== | ==== Breadboard prepartion ==== | ||
So get all your stuff together and build up the breadboard. Here is the schematic. If your Programmer has male headers, you can plug it directly into the breadboard. {{ : | So get all your stuff together and build up the breadboard. Here is the schematic. If your Programmer has male headers, you can plug it directly into the breadboard. {{ : | ||
<WRAP center round alert 60%> | <WRAP center round alert 60%> | ||
- | Short Cut on Board! EORROR! | + | \\ |
+ | The data line of the 1Wire bus (blue) \\ is not connected correctly in the diagram above! | ||
</ | </ | ||
user/jan001/intro_iot_tasmota_nig.1656407661.txt.gz · Last modified: 2022/06/28 11:14 by rolf001