Differences

This shows you the differences between two versions of the page.

--- user:jan001:intro_iot_tasmota_nig [2022/06/28 11:14] – [Breadboard prepartion] rolf001
+++ user:jan001:intro_iot_tasmota_nig [2023/03/28 15:21] (current) – [Doing stuff] rolf.becker
@@ Line 64: / Line 64: @@
 Allons-y!
+==== DS18B20 Pinout ====
+  * Cable VErsion: red -> 3.3V , blue -> GND , yellow -> data (1wire protocol)
+  * Breakout board version: "+" -> 3.3V , "-" -> GND, out -> data
 ==== Breadboard prepartion ====
 So get all your stuff together and build up the breadboard. Here is the schematic. If your Programmer has male headers, you can plug it directly into the breadboard. {{ :user:jan001:intro-iot_bb.png?600 |}}
 <WRAP center round alert 60%>
-Short Cut on Board! EORROR!
+\\
+The data line of the 1Wire bus (blue) \\ is not connected correctly in the diagram above!
 </WRAP>