user:jan001:intro_iot_tasmota_nig
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| user:jan001:intro_iot_tasmota_nig [2023/03/08 15:39] – [Breadboard prepartion] rolf.becker | user:jan001:intro_iot_tasmota_nig [2023/03/28 15:21] (current) – [Doing stuff] rolf.becker | ||
|---|---|---|---|
| Line 64: | Line 64: | ||
| Allons-y! | Allons-y! | ||
| + | ==== DS18B20 Pinout ==== | ||
| + | |||
| + | * Cable VErsion: red -> 3.3V , blue -> GND , yellow -> data (1wire protocol) | ||
| + | * Breakout board version: " | ||
| ==== Breadboard prepartion ==== | ==== Breadboard prepartion ==== | ||
| So get all your stuff together and build up the breadboard. Here is the schematic. If your Programmer has male headers, you can plug it directly into the breadboard. {{ : | So get all your stuff together and build up the breadboard. Here is the schematic. If your Programmer has male headers, you can plug it directly into the breadboard. {{ : | ||
| Line 69: | Line 73: | ||
| <WRAP center round alert 60%> | <WRAP center round alert 60%> | ||
| \\ | \\ | ||
| - | The data line of the 1Wire bus (blue) is not connected correctly in the diagram above! | + | The data line of the 1Wire bus (blue) |
| </ | </ | ||
user/jan001/intro_iot_tasmota_nig.1678286393.txt.gz · Last modified: 2023/03/08 15:39 by rolf.becker