eolab:weather_station:diy:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
eolab:weather_station:diy:start [2024/04/11 17:12] – [Tipping Bucket Rain Gauge] henrik.schoofs | eolab:weather_station:diy:start [2024/04/18 11:29] (current) – [Wind Velocity (Anemometer)] rolf.becker | ||
---|---|---|---|
Line 18: | Line 18: | ||
| Data Sheet: {{eolab: | | Data Sheet: {{eolab: | ||
- | |{{ : | + | |{{: |
- | |The current consumption of the bucket | + | |Inside of the Rain Gauge and PCB| |
- | |{{ : | + | |
+ | == Current Consumption == | ||
+ | |{{ : | ||
+ | |The current consumption of the rain gauge with 5V supply voltage is around 3.5mA on average. The two spikes in the screenshot are caused by the bucket tipping. The oscillation in the voltage is caused by a blinking LED on the PCB.| | ||
+ | |{{ : | ||
|Reading data from it increases the current to around 25mA for 60ms.| | |Reading data from it increases the current to around 25mA for 60ms.| | ||
+ | |||
Line 33: | Line 38: | ||
| [[https:// | | [[https:// | ||
| Data Sheet: {{eolab: | | Data Sheet: {{eolab: | ||
+ | |||
+ | |{{: | ||
+ | |{{: | ||
+ | |{{: | ||
==== Wind Direction ==== | ==== Wind Direction ==== | ||
Line 42: | Line 51: | ||
| Data Sheet: {{eolab: | | Data Sheet: {{eolab: | ||
+ | |{{: | ||
+ | |{{: | ||
+ | |{{: | ||
==== Air Temperature ==== | ==== Air Temperature ==== | ||
eolab/weather_station/diy/start.1712848333.txt.gz · Last modified: 2024/04/11 17:12 by henrik.schoofs