Differences

This shows you the differences between two versions of the page.

--- emrp2020:azam01:start [2020/11/19 16:41] – [TTGO LoRa32 OLED V1] rolf001
+++ emrp2020:azam01:start [2021/08/24 17:35] (current) – external edit 127.0.0.1
@@ Line 7: / Line 7: @@
 :!: Important: Please notice that we are using **Version 1** or the TTGO LoRa32 module!
+The **TTGO LoRa32 OLED V1 module** is based on the ESP32 microcontroller. The ESP32 itself is capable of communicating via WIFI as well as BLE (Bluetooth low energy). The latter can be used to communicate directly with a smartphone. This TTGO module is further equipped with a LoRa transceiver (SX1276, 868/915 MHz) to provide an additional communication channel. Furthermore it has a nice OLED display to communicate with humans.
 {{https://i2.wp.com/randomnerdtutorials.com/wp-content/uploads/2019/10/TTGO-LoRa-ESP32-Dev-Board-Receiver.jpg?600}} \\
 //Fig.: TTGO LoRa32 OLED **V1**. \\ Image Source: [[https://randomnerdtutorials.com/ttgo-lora32-sx1276-arduino-ide/|RandomNerdTutorials]]//
+\\
+{{ :emrp2020:azam01:ttgo_lora32_v1_bottom.jpg?direct&800 |}}
+//Fig.: TTGO LoRa32 OLED V1, **bottom view**.//
 \\
@@ Line 17: / Line 24: @@
 ===== Mount the TTGO LoRa32 V1 module on a breadboard =====
+The problem is that the breadboards we are using have very tight clamps to push the pins in.
 {{vimeo>481272177}}
 \\
-===== Read analog potentiometer voltages with TTGO LoRa32 =====
+===== Read analog potentiometer voltages with TTGO LoRa32 V1 =====
+A potentiometer is used to simulate an environmental sensor.
 {{vimeo>481268991}}