colmayor:iot-workshop:intro
Table of Contents
Introduction to IoT
1. IoT Intro Presentation
2. Setup Development Environment
- Install Arduino IDE, for more information see the Official documentation
3. Hardware Review
- Dev Board: Wemos D1 Mini
- Microcontroller: ESP8266 12-E Chip ESP8266 hardware review
4. Soldering
Here it gets practical! You need to solder the microcontroller and some of the sensors, which you will need in the next session.
Fig. 1: In Action at UNICAES
5. Coding Warm-up
Now let's check if your Microcontroller works. Also, you will learn how to upload your first sketch. Basic Blink example:
- Blink.ino
void setup() { // initialize digital pin LED_BUILTIN as an output. pinMode(LED_BUILTIN, OUTPUT); } // the loop function runs over and over again forever void loop() { digitalWrite(LED_BUILTIN, HIGH); // turn the LED on (HIGH is the voltage level) delay(1000); // wait for a second digitalWrite(LED_BUILTIN, LOW); // turn the LED off by making the voltage LOW delay(1000); // wait for a second }
colmayor/iot-workshop/intro.txt · Last modified: 2024/09/05 14:37 by harley.lara