Requirements:

• Basic programming knowledge, preferably C or C++.
• Basic knowledge in electricity

Materials:

• Personal computer
• Operating system: Any
• Internet connection
• Dev board: Wemos D1 Mini
• Mico-USB to USB-A cable
• Breadboard
• Jumper wires
• Sensors:
  • sensor 1
  • sensor 2
  • sensor x
• Actuator:
  • actuator 1
  • actuator x

Session Outline:

Day 1: Introduction to IoT:

• Introduction to IoT
• Setup development environment
  • Install Arduino IDE
  • Install libraries
  • Drivers
• Hardware review
• Coding Warm-up
  • LED Blink
  • Sensor reading?

Day 2: Sensor and Communication:

• Just analog (Capacity sensor)
• Onewire (temperature sensor)
• I2C (ToF sensor)

Day 3: IoT Communication:

• MQTT

Day 4: NIG stack:

• Setup docker
• Node-RED
• Influx
• Grafana